REPLACEMENT BRASS SCREW
This is the LEFT HAND THREAD brass screw used in the output shaft of our timers. If you break the screw, you may be able to get the broken part out by following the procedures discussed in the Hints section of this site. If you can not get it out, you will need to send the timer to us to have the entire gear replaced. We have requests all the time for spare screws and have decided to just make them a standard part. Remember, never never put Loctite on this screw. You will not get the broken piece out.
NOTE: These brass screws are not for the 3F timer as they are too short. The 3F must use the custom made steel screw. See Here for the correct screw for the 3F.